Product quality review associated with the manufacturing process. Impacts quality of own work and the work of others on the team. Executes standard operational/technical tasks typically subject to instructions and work routines. There is latitude to rearrange the sequence to complete task/duties based on changing work situations.**Job Description** =================== **Requirements/Requirements** * Perform visual inspection and dimensional control of all incoming components from wind farms or suppliers. * Perform non\-destructive tests on gear and shaft parts (inspection for magnetic particles and penetrating liquids) * Apply the UT technique to identify potential shaft defects as needed. * Be able to perform standard quality control checklists and measurements according to drawing specifications in the repair shop. * Mastery of the use of metrological precision tools for inspection (micrometers, rugosmeters, hardness tests, UT, 3D measuring devices/laser scanning) * Supervision of the gearbox load test procedure, monitoring temperatures, vibrations, cleanliness and oil pressure. * Perform the electrical tests of the cabinets mounted on the refurbished Nacelles, Hubs, as well as carry out the final operational tests of the unit. * Occasionally, it is necessary to work in narrow areas using ladders, platforms, scissor and arm lifts, more than 4 m above the ground. * Possess in\-depth knowledge and the ability to use all the tools associated with assembling units according to the required specifications: + Forklifts. + Mobile elevating work platforms + Lifting equipment, wall cranes and bridge cranes + Hydraulic and electric tools/torque wrench. + Other tools include, but are not limited to, impacts, drills, magnetic drills, drills, angle grinders, sanders, basic hand tools (manual and pneumatic) + Measuring tools, gauges, oil washing equipment. + Uses of hand tools * Read and understand mechanical design, engineering drawings. * Follow all EHS guidelines and policies. * Follow good environmental practices and waste management procedures. Separate the waste in the corresponding containers in the Repair Room. * Use and management of Quality documentation * Traceability * Calibration **Required Qualifications** * School Diploma of Mechanics, Electricity and/or Electronics (FP2 in Spain) * Minimum of 2 years of experience working in a repair shop. Preferably from the Wind or Aeronautical Sector. * Knowledge of ALSPA MD 2000 Frequency Converter * Knowledge of ISO, AGMA and other standards applicable to the design, repair and failure modes of reducers and shafts. * Knowledge of ISO 9001, 14001 and 45001 Standards. * Be able to understand and read the lubrication analysis, according to ISO 4406\. * Complete knowledge of bearing and gear mounting procedures and bearing clearance tolerances. * Be able to inspect using borescopic devices. * Knowledge of vibration and temperature measurement devices, being able to understand data and readings from vibration monitoring equipment and data trends. * Level B2 in English **Desired Characteristics** * High ability to read, understand and follow mechanical, engineering drawings * It is also essential to have previous experience and certification in handling forklifts, personal lifts, and overhead cranes. * Self\-motivated to work with a minimum of guidance and willingness to learn from others * END Level II certification training. * UT Level II Inspection Certification Training * CAT II Vibration Analysis Certification Training **Additional Information** ========================== **Relocation Assistance Provided:** No